Standby Or Hibernation Problems - IBM ThinkPad R40e Troubleshooting Manual

Solving computer problems
v When the computer is turned on.
v When the computer resumes normal operation.
v When the TrackPoint is pressed for a long time.
v When the temperature changes.
Problem: The PS/2
Solution: Make sure that the TrackPoint and the touch pad are set to
Automatic in the ThinkPad Configuration Program. Then detach the PS/2
Port mouse or the PS/2
the touch pad. If the TrackPoint and the touch pad work, the error might be
due to the PS/2
Note: Some models have the TrackPoint only, without a touch pad and its
Make sure that the cable for the PS/2
device is securely connected to ThinkPad Port Replicator, Port Replicator II or
MiniDock.
Note: For more information, see the manual supplied with the mouse.
Problem: The mouse buttons do not work.
Solution: If your ThinkPad computer has the TrackPoint only, this problem
may occur.
Change the mouse driver to Standard PS/2
IBM PS/2 TrackPoint. Drivers are provided in the C:\IBMTOOLS\DRIVERS
directory on your hard disk drive. If your hard disk drive does not contain
device drivers, refer to the ThinkPad Web site. For access to this Web site,
open Access IBM by pressing the Access IBM button.

Standby or hibernation problems

Problem: The computer enters standby mode unexpectedly.
Solution: If the processor reaches a temperature that is too high, the computer
automatically enters standby mode to allow the computer to cool and to
protect the processor and other internal components. Also, check the settings
for standby mode, using Battery MaxiMiser.
Problem: The computer enters standby mode immediately after Power-on
self-test (POST) (the standby indicator light turns on).
20
®
ThinkPad R40 Series Service and Troubleshooting Guide
®
Port mouse or the PS/2 pointing device does not work.
®
pointing device, and try using the TrackPoint and
®
Port mouse or the PS/2
buttons.
Some models does not support Mini Dock, Port Replicator, and Port
Replicator II.
®
pointing device.
®
Port mouse or the PS/2
®
Port Mouse, and then reinstall
®
®
pointing