Table of Contents
Advertisement
Replacing the Optical Drive
WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 11. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1
Connect the interposer to the optical drive.
2
Align the screw holes on the optical-drive bracket with the screw holes on the optical
drive and replace the screws that secure the optical-drive bracket to the optical
drive.
3
Align the slot on the optical drive with the alignment posts on computer base and
place the optical drive in the computer base.
4
Replace the screws that secure the optical drive to the computer base.
5
Connect the optical-drive cable to its connector on the system board.
Postrequisites
1
Replace the battery pack. See "Replacing the Battery Pack" on page 17.
2
Replace the base cover. See "Replacing the Base Cover" on page 15.
3
Follow the instructions in "After Working Inside Your Computer" on page 13.
24
|
Replacing the Optical Drive
Before working inside your computer, read the safety
Advertisement
Table of Contents
