FujiFilm FinePix F11 Owner's Manual page 59

Warning Displays
eThe table below lists the warnings that are displayed on the LCD monitor.
Warning Displayed Explanation
The battery is low or completely out of
(Lit red)
charge.
(Blinking red)
|
There is a strong likelihood of camera
shake because the shutter speed is slow.
The AF (autofocus) cannot work effectively.
Aperture/Shutter speed display Outside the AE continuous range.
(Lit red)
Camera malfunction or fault.
FOCUS ERROR
ZOOM ERROR
No xD-Picture Card is inserted.
NO CARD
i The xD-Picture Card is not formatted.
i The xD-Picture Card contact area is
soiled.
CARD NOT INITIALIZED
i Camera fault.
i The xD-Picture Card contact area is
soiled.
CARD ERROR i The xD-Picture Card format is incorrect.
i Camera fault.
i The xD-Picture Card is damaged.
The xD-Picture Card is full.
CARD FULL
i The data could not be recorded due to
an xD-Picture Card error or a
connection error between the xD-
WRITE ERROR
Picture Card and camera.
i The image cannot be recorded as it is
too large to fit in the available space on
the xD-Picture Card.
The timing for recording was incorrect
BUSY because the xD-Picture Card was
formatted on a PC.
The frame number has reached 999-9999.
FRAME NO. FULL
i The played back file was not recorded
correctly.
i The xD-Picture Card contact area is
soiled.
READ ERROR
i Camera fault.
i An attempt was made to play back the
movie or the image that was not
116 recorded on this camera.
Remedy
Charge the battery or load a fully charged battery.
Use flash photography. However, use a tripod for
some scenes and modes.
i If the image is too dark, take the picture at a
distance of around 2 m (6.6 ft.) from the subject.
i Use AF lock to take the picture.
The picture can be taken, but the correct
brightness (exposure) will not be obtained.
i Turn the camera on again, taking care not to
touch the lens.
i Turn the camera off and on again. If the
message still appears, contact your FUJIFILM
dealer.
Insert an xD-Picture Card.
i Format the xD-Picture Card on the camera.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
Erase some images or use an xD-Picture Card
that has ample free space.
i Re-insert the xD-Picture Card or turn the
camera off and then on again. If the message
still appears, contact your FUJIFILM dealer.
i Use a new xD-Picture Card.
Use an xD-Picture Card that was formatted on
the camera.
1 Insert a formatted xD-Picture Card into the
camera.
2 Set "RENEW" as the FRAME NO. setting in
˜
the " " SET-UP menu.
3 Start taking pictures (The frame number starts
from "100-0001").
4 Set "CONT." as the FRAME NO. setting in the
" ˜ " SET-UP menu.
i This file cannot be played back.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
i The movie and image cannot be played back.
Warning Displayed Explanation
An attempt was made to show 5,000 or
TOO MANY FRAMES
more images by date sorting.
i A protected file was encountered.
i An attempt was made to add a voice
PROTECTED FRAME
memo to protected file.
i An attempt was made to rotate a
protected file.
i The voice memo file is faulty.
t ERROR
i Camera fault.
An attempt was made to trim a 0.3M
` CAN NOT TRIM
image.
i An attempt was made to trim an image
shot using a camera other than FinePix
CAN NOT TRIM
F11.
i The image is damaged.
Prints were specified for 1000 or more
frames in the DPOF frame settings.
DPOF FILE ERROR
An attempt was made to specify DPOF
CAN NOT SET DPOF
settings for an image that was not
r CAN NOT SET DPOF
supported by DPOF.
An attempt was made to rotate a movie or
CAN NOT ROTATE
an image shot using a camera other than
r CAN NOT ROTATE
FinePix F11.
The camera is not connected to a PC or
COMMUNICATION
printer.
ERROR
Displayed for PictBridge.
PRINTER ERROR
Displayed for PictBridge.
PRINTER ERROR
RESUME?
Displayed for PictBridge.
CANNOT BE PRINTED
Displayed for PictBridge.
u PRINTING
Remedy
No more than 4,999 images can be shown by
date sorting.
i Protected files cannot be erased. Remove the
protection.
i Protected files cannot be added to voice
memos. Remove the protection.
i Protected files cannot be rotated. Remove the
protection.
i The voice memo cannot be played back.
i Contact your FUJIFILM dealer.
The image cannot be trimmed.
The image cannot be trimmed.
The maximum number of frames for which prints
can be specified on the same xD-Picture Card is
999.
Copy the images for which you want to order
prints onto another xD-Picture Card and then
specify the DPOF settings.
DPOF printing cannot be used with this image
format.
These images cannot be rotated by image
formats.
i Check that the USB cable (mini-B) is connected
correctly.
i Check that your printer is turned on.
i Check that the printer is not out of paper or out
of ink.
i Turn the printer off briefly and then turn it back
on.
i Refer to the user manual supplied with your
printer.
Check that the printer is not out of paper or out of
ink. Printing automatically restarts when the error
is cleared. If the message still appears after
checking, press the "MENU/OK" button to restart
printing.
i Refer to the user manual for the printer being
used and check whether the printer supports the
JFIF-JPEG or Exif-JPEG image format. If not,
the printer cannot print the images.
i Movie images cannot be printed.
i Was the image data photographed using
FinePix F11?
You may not be able to print some images
photographed on other cameras.
This message appears when printing is performed
from a FUJIFILM printer that supports PictBridge.
Refer to the Owner's Manual for the printer for
details.
117