USB board
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the keyboard (see
6.
Remove the top cover (see
Remove the USB board:
1.
Release the ZIF connector (1) to which the USB cable is attached, and then disconnect the USB
cable from the system board.
2.
Remove Phillips PM2.5×5.6 screw (2) that secures the USB board to the base enclosure.
3.
Remove the USB board (3) and cable.
Reverse this procedure to install the USB board.
Battery on page
30).
Keyboard on page
31).
Top cover on page
33).
Spare part number
726204-001
Component replacement procedures
41