Storing Components - Dell Force10 Z9000 Manual

The system is powered-up as soon as the power cord is connected between the system and the power
source.
CAUTION: Always disconnect the power cable before the power supply slots are serviced.
CAUTION: The power supply cord is used as the main disconnect device. Ensure that the socket-outlet is
located/installed near the equipment and is easily accessible.

Storing Components

If you do not install your system and components immediately, Dell Force10 recommends properly
storing the Z9000 and all optional components until you are ready to install them.
WARNING: Electrostatic discharge (ESD) damage can occur when components are mishandled. Always
wear an ESD-preventive wrist or heel ground strap when handling the Z9000 and its accessories. After you
remove the original packaging, place the Z9000 and its components on an antistatic surface.
Follow these storage guidelines:
• Storage temperature must remain constant ranging from -4° to 158° F (-20°C to 70° C).
• Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.
• Store in a dust-free environment.
Site Preparations | 17