Replace A Dc Power Supply - Dell Force10 Z9000 Manual

Replace a DC Power Supply

To replace a DC power supply, follow these steps:
NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot as this may damage the PSU or
the chassis.
Step Task
Turn the DC power source OFF.
1
Remove the small plastic cover over the DC cable connectors. Do not throw the cover away as you will replace
2
it when you complete the installation.
Disconnect the power cable from the PSU.
3
Use the grab handle to slide the PSU out of the power supply bay.
4
Use the grab handle on the replacement unit to slide it into the power supply bay.
5
Replace the small plastic cover over the DC cable connectors.
6
Tighten the securing screw on the side of the PSU. Ensure that the PSU is secure.
7
Attach the power cables.
8
Turn the DC power source ON.
9
30 | Power Supplies