Learning-Switch-Assist; Z-Series, S4810; Multiple-Fwd-Table Enable - Dell Force10 Software Defined Networking Deployment Manual

Example (VLAN
FTOS(conf)#openflow of-instance 1
interface type)
FTOS(conf-of-instance-1)#interface-type vlan
FTOS(conf-of-instance-1)#
Usage Dell Force10 does not recommend selecting
Information of-vlans are required in a single instance. If
of available ACL flows is reduced by half (128 of 256 entries or 256 of 512 entries).
Legacy LLDP must be disabled on of-ports to avoid conflicts with the controller's version of
LLDP.
Dell Force10 does not recommend configuring global STP instances on ports using both legacy
VLANs and OF VLANs.
Related openflow of-instance
Commands

learning-switch-assist

Specify if learning bridge flows need to be interpreted by the switch.

Z-Series, S4810

Syntax learning-switch-assist enable
Defaults Disabled
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0)
Usage This command is used for OpenFlow instances with an interface-type of either vlan or any to
Information
allow the switch to interpret flows and update L2 tables to reduce the number of flows installed
for VLANs.
Related openflow of-instance
Commands
interface-type

multiple-fwd-table enable

Advertise all forwarding tables (IFP, VLAN, L2, and L3) to the controller.
Z-Series, S4810
Syntax multiple-fwd-table enable
Defaults Disabled
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0)
any for the interface-type unless both of-ports and
any is selected for the interface-type, the number
Create or modify an OpenFlow instance.
Introduced on Z9000 and S4810.
Create or modify an OpenFlow instance.
Select the OpenFlow instance interface type (port, VLAN, or any).
Introduced on Z9000 and S4810.
31