Flow-Map; Z-Series, S4810; Interface-Type - Dell Force10 Software Defined Networking Deployment Manual

flow-map

Specify if flows installed by the controller should be interpreted by the switch for placement in L2 or L3 tables.

Z-Series, S4810

Syntax flow-map {l2|l3} enable
Parameter
l2
l3
Defaults None (not enabled)
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0)
Usage L2 flow-mapping is not supported on OpenFlow instances with an interface-type of "port."
Information
Related openflow of-instance
Commands

interface-type

Specify the type of interface (port, VLAN, or any) for the OpenFlow instance.
Z-Series, S4810
Syntax interface-type {any|port|vlan}
Defaults port
Parameter
any
port
vlan
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0)
30
Enter l2 to interpret Layer 2 flows.
Enter l3 to interpret Layer 3 flows.
Introduced on Z9000 and S4810.
Create or modify an OpenFlow instance.
any to enable configuration of physical interfaces,
Enter the keyword
LAGs, and VLANs on the selected OF instance.
Default. Enter the keyword port to enable configuration of LAGs or
physical interfaces on the selected OF instance.
vlan to enable configuration of VLANs on the
Enter the keyword
selected OF instance.
NOTE: You must associate the OF instance with the VLAN when
the VLAN is created.
Introduced on Z9000 and S4810.