The S2410 System; Physical Interfaces; Required Equipment - Dell Force10 S2410-01-10GE-24P Manual

The S2410 System

This chapter contains these sections:
•

Physical Interfaces

• Required Equipment on page 7
• Features on page 8
• Ports on page 8
• System Status on page 9
Physical Interfaces
The Dell Force10 S2410 is a Layer 2 switch that is available in two models — the S2410CP and the
S2410P. The primary difference is that the S2410P contains 24 built-in 10-gigabit Ethernet (10G) XFP
ports, while the S2410CP contains 20 built-in 10G BaseCX4 ports and four 10G XFP ports.
Figure 2-1. The S2410CP (Front View)
1 3
A A
CLASS 1 LASER PRODUCT L L
A A
LASERPRODUKT DER KLASSE1
Assy Assy
L L
2 4
Serial # Serial #
Label Label
4 XFP Ports 4 XFP Ports
(Assembl y and Seri a l # ) (Assembl y and Seri a l # )
Figure 2-2. The S2410 (Rear View
)

Required Equipment

The following items are necessary to install the S2410 system:
• Two grounded AC power sources
5 7 9
A A A A
L L L L
A A A A
L L L L
6 8 10
20 CX4 Ports (S2410CP) or 20 CX4 Ports (S2410CP) or
20 XFP Ports (S2410P) 20 XFP Ports (S2410P)
Dual AC Power Receptacles
11 13 15
A A A
L L L
A A A
L L L
12 14 16
Vents
Catalog #
10/100 Ethernet Management Port 10/100 Ethernet Management Port
17 19 21 23
A A A
L L L
A A A
L L L
18 20 22 24
The S2410 System
2
S2410-01-10GE-24CP
System
Alarm
10/100
Ethernet
PSU-A
Console
PSU-B
Status LEDs Console Port Status LEDs Console Port
| 7