Physical Placement; Connecting To The Cable System - SMC Networks EZ Connect SMC8002CM Installation Manual

Physical Placement

Place the cable modem on a stable, flat surface such as a desktop, close to the CATV
cable drop connection and all devices to be connected. The surrounding areas of the
cable modem must remain unobstructed to ensure adequate airflow and to prevent the
unit from overheating.
Caution: Do not place the cable modem on an uneven or soft surface.

Connecting to the Cable System

Ø Verify that the cable modem is not connected to the power source. It will generate
installation difficulty if you power on the cable modem before connect RF coaxial
cable.
Ø Locate the RF coaxial cable from the CATV wall outlet.
Ø Install a cable splitter/directional coupler if it is needed to separate signals for TV
and PC usage.
Ø Connect the RF coaxial cable to the cable modem's F-connector. Hand-tighten the
connector, making sure it is finger-tight.
Caution: Do not over-tighten the connector because doing so can break off the
connector.
Ø Make sure all other coaxial cable connectors and all intermediate splitters,
couplers, or ground blocks are securely tightened from the distribution tap to the
cable modem.
Note: Loose connectors inside the building or residence can cause intermittent
cable modem operation.
Caution: To ensure compliance with FCC limits, connection to the cable system
must be made with a high-quality, shielded cable. If the quality or general
condition of the coaxial cable is in question, it is recommended that you replace
the coaxial cable.
SMC8002CM Installation Guide
10