Input Signal (Pc Input Mode Only); Dnr (Digital Noise Reduction); Quick Shoot - Sharp AQUOS LC-32GA4E Operation Manual

Useful adjustment settings

Input signal (PC input mode only)

• Some input signals may have to be registered manually
to display properly.
• The pairs of input signals (resolutions) in the list below
are not distinguishable when received. In such case, you
have to set the correct signal manually. After setting once,
it will display when the same signal (resolution) is input
again.
640g400
640g480
1024g768
NOTE
• You can only select the "Input Signal" on the Setup menu
when receiving one of the 6 input signals listed above.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Input Signal" and then
press OK.
4
Press a/b to select the desired input signal
on the display.
44
720g400
848g480
1280g768

DNR (Digital Noise Reduction)

Produces a clearer video image.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Option".
3
Press a/b to select "DNR", and then press
OK.
• Some items may be greyed out. They are not
selectable.
4
Press a/b to select the desired level (Off,
High, Low), and then press OK.

Quick Shoot

Improves LCD response when viewing fast-moving
images. The effect is greater at low room temperatures
(at or below 15˚C/59˚F).
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Option".
3
Press a/b to select "Quick Shoot", and then
press OK.
4
Press c/d to select "On", and then press
OK.
NOTE
• Quick Shoot may cause image noise. If this occurs, turn
the function "Off".