Input Skip; Input Signal (Pc Input Mode Only); Input Signal - Sharp AQUOS LC-42G7H Operation Manual

Useful adjustment settings

Input Skip

This setting allows you to skip the HDMI or DVI input
on the "Input Select" menu.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a/b to select "Input Skip", and then
3
press ENTER.
Press a / b to select the Input (INPUT4,
4
INPUT5 or INPUT6) you wish to skip, and then
press ENTER.
INPUT 4 (HDMI1)
INPUT 5 (HDMI2)
INPUT 6 (DVI)
Press c / d to select "Yes", and then press
5
ENTER.
Press MENU to exit.
6
34
Yes No

Input Signal (PC input mode only)

• Some input signals may have to be registered manually to
display properly.
• The pairs of input signals (resolutions) in the list below are
not distinguishable when received. In such case, you have
to set the correct signal manually. After setting once, it will
display when the same signal (resolution) is input again.
1024 x 768
NOTE
• You can only select the "Input Signal" on the Setup menu
when receiving one of the 2 input signals listed above.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Input Signal" and then
3
press ENTER.
Press a / b to select the desired input signal
4
on the display.
1360 x 768
1024 x 768
1360 x 768
(Example)