Skipping Channels; Setting The Decoder; Setting The Child Lock; Setting The Booster - Sharp AQUOS LC-32GA4E Operation Manual

Basic adjustment settings
Manual setting for each channel (continued)

Skipping channels

Channels with "Skip" set to "On" are passed over when
using Pr/Ps even if selected while watching the
image from the TV.
1
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
2
Press a/b to select "Skip", and then press
OK.
• Skip menu displays.
3
Press a/b to set "Skip" to "On", and then
press OK.

Setting the decoder

When connecting a decoder to the unit, you need to
assign the terminal input.
1
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
2
Press a/b to select "Decoder", and then
press OK.
• Terminal inputs information displays.
(Off, INPUT1, INPUT2, INPUT3)
3
Press a/b to set "Decoder" to "INPUT1",
"INPUT2, or "INPUT3" and then press OK.
NOTE
• "Off" is factory preset value.
• "INPUT1" is the recommended selection.
24

Setting the child lock

You can block the viewing of any channel.
1
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
2
Press a/b to select "Lock", and then press
OK.
• Child lock menu displays.
Press a/b to set "Lock" to "On", and then
3
press OK.
NOTE
• See page 47 for setting PIN.
• When "Lock" is set to "On" for a channel, "Child lock has
been activated." displays , and the image and sound of
the channel are blocked.
• When pressing OK while "Child lock has been activated."
displays, PIN input menu will display. Inputting the correct
PIN lifts the child lock temporarily until the power is turned
off.

Setting the booster

Picture quality may improve in regions with weak signal
strength using this function.
1
Press a/b/c/d to select the channel you
want to edit, and then press OK.
2
Press a/b to select "Booster", and then
press OK.
• Booster menu displays.
3
Press a/b to set "Booster" to "On", and then
press OK.
NOTE
• If signal strength is strong enough for the selected
channel, the effect is negligible and may produce
instability. In such case, select "Off".