Connecting External Speakers; External Audio Bypass - Sharp AQUOS LC-32GA4E Operation Manual

Using external equipment

Connecting external speakers

Rear view
Make sure to disconnect the connected speaker
cables in advance when connecting external
speakers.
Make sure to connect the speaker terminal and
cable polarity (L, +) properly.
• The speaker terminals have plus (L) and minus (+)
polarity.
• Plus is red and minus is black.
• The cables are also divided into plus and minus.
• When connecting the left/right speakers, be sure to
connect the plus/minus terminals with the correct cables.
NOTE
• Unplug the AC cord from the AC outlet before installing
the speakers.
CAUTION
• Make sure external speakers have 4 ohm and 10 watt
specifications.
• Connect the plus/minus terminals with the correct cables.
Incorrect connection may cause a short.
How to connect the
speaker cable
Pull up the
1 1 1 1 1
lid.
Insert the
2 2 2 2 2
edge of the
cable.
Put the lid
3 3 3 3 3
back
down.

External Audio Bypass

External Audio Bypass automatically optimises the
audio quality to suit internal (supplied) speaker.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Speaker Setup", and
then press OK.
4
Press a/b to select "External Audio
Bypass", and then press OK.
5
Press c/d to select "Yes" or "No", and then
press OK.
Selected item
Sets the optimum audio for the internal
No
(supplied) speaker.
When you are using your own speakers,
Yes
output the original sound.
NOTE
• External Audio Bypass is greyed out when Dolby Virtual
is set to "On".
• When Dolby Virtual is on, External Audio Bypass
automatically sets to "Yes".
Description
37