NEC Express5800/320Fd-LR User Manual page 96

4-36 Linux Setup
After the procedure 2., the screen shows the message that the process is going on. If the
3.
screen does not show any error and goes back to the main menu of ftdiskadm, that shows
striping array is properly created. Confirm the striping array created with ftdiskadm.
# ftdiskadm
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions (RAID1)
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 1
[List RAID Arrays]
Name Partition
================================================================
< Striping Array (RAID1+0) >
md8
< Mirroring Array (RAID1)
md0 /boot
md1 swap
md2 /
md3 /var/crash
md4
md5
md6
md7
<<< Confirm following points: 1) Striping array md8 is created (Unused
RAID device number is automatically allocated). 2) Status is
"ACTIVE". 3) There is the RAID 1 device name defined in the procedure
2 in "Member". >>>
This is the end of the procedure to create striping array. On the main menu of ftdiskadm,
4.
enter "q" in Command to quit ftdiskadm. The file system of the created striping array is
ext3. If you would like to change the file system, use mkfs command.
(RAID1)
(RAID1+0)
(RAID1+0)
(Label)
( - ) ACTIVE
>
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
Status Member
md4
(1)sda1 (4)sdd1
(1)sda2 (4)sdd2
(1)sda3 (4)sdd3
(1)sda5 (4)sdd5
(2)sdb1 (5)sde1
(2)sdb2 (5)sde2
(3)sdc1 (6)sdf1
(3)sdc2 (6)sdf2
md6