Removing A Hard Disk Drive From The Hard Drive Bay - NEC Express5800/120Rf-2 User Manual

Removing a Hard Disk Drive from the Hard Drive Bay

Perform the following steps to remove a hard disk drive.
NOTE:
If removing a failed hard disk drive, confirm the slot in which the disk
lamp of the hard disk drive is amber before starting the removal. See Figure 4-61,
A.
1. Observe the safety and ESD precautions listed under General Information
and Static Precautions at the beginning of this chapter.
2. Perform the steps in "Preparing Your System for Upgrade" described earlier
in this chapter.
3. Locate the slot in which you are going to install a hard disk drive.
4. Push the latch to the left to unlock, and then open the tray handle.
See Figure 4-62.
5. Firmly hold the handle and hard disk drive, and pull out the hard disk drive
carrier.
6. If using the server with the hard disk drive removed, install a dummy tray in
the empty slot.
A
4-54 Upgrading Your System
Figure 4-61. Disk LED Lamps
B
Figure 4-62. Removing a Hard Disk Drive
A
C