Log And Total Log; Reset Log; Reset Total Log - Navman MULTI 3100 Installation And Operation Manual

Calibrate by speed
In this method, travel at a measured, constant speed.
Use the speed displayed on a GPS receiver, follow
another boat travelling at a known speed or make a
timed run over a known distance.
Note that for accurate calibration:
The speed from a GPS receiver should be
above 5 knots.
The speed from another paddlewheel
transducer e.g. another boat - should be
between 5 and 20 knots.
Best results are achieved in calm conditions
where there is minimal tidal current (best at
high or low tide).
Continue travelling at this measured, constant speed
and calibrate the speed as follows:
1 Press + several times until the Speed
Calibration screen is displayed (after this, it
does not matter if the boat speed changes):
2 Press or to change the displayed speed
to the measured boat speed.
3 Press .

4 Log and total log

The MULTI 3100 has two distance logs:
LOG: Trip distance. The distance travelled
since log was reset.
TOTAL LOG: Total distance. The distance
travelled since total log was reset:
MULTI 3100 Installation and Operation Manual
Calibrate by log
In this method, travel a known distance in a straight
line over a course. Best results are achieved in calm
conditions where there is minimal current (best at
high or low tide). Tidal effects may be reduced by
making the trip twice, parallel to the current, once in
each direction.
1
2
3
Measured
speed
4
5
The log units are NM, KM or M (miles) and
correspond to the speed units, for example if you set
the speed units to KPH then the log units are KM
(see section 3-1).

4-1 Reset log

Resetting zeros the log (trip distance):
1
2

4-2 Reset total log

Resetting zeros the total log (total distance), as well
as the log and avg speed:
Total log
1
2
At the start of the course, reset the trip log (see
section 4-1). Travel in a straight line over the
course, then repeat in the other direction.
At the end, note the trip log distance (see
section 4).
Press + several times until the Log
Calibration screen is displayed:
Press or to change the displayed
distance travelled to the actual distance you
travelled over the course.
Press .
Press until LOG is displayed.
Press + .
Press until TOTAL LOG is displayed.
Hold + for 5 seconds.
Distance
travelled
9