Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Navman MULTI 100
Summary of Contents for Navman MULTI 100
- Page 1 NAVMAN RESET MULTI NAVMAN...
-
Page 2: Table Of Contents
Troubleshooting Chart ..........16 M100/ENG/1D NAVMAN M100 User Manual... -
Page 3: Specification
3 conductor cable for or kph. NMEA and power. Display is backlit for Sea temperature Night Operation DEPTH Depth/speed SPEED trend indicators Multi-function SPEED display Alarm DEPTH TOTAL indicator Depth/speed trend indicators MULTI RESET NAVMAN M100 User Manual... -
Page 4: Installation
Installation Location Mounting The NAVMAN M100 is designed for above or The mounting surface must be flat. Use the below deck installation. Select a position that is: template to set the centre of the fixing hole. • At least 300mm from a compass •... -
Page 5: Wiring Connection
NMEA output to repeater Speed Depth Transducers Multiple Instruments The NAVMAN M100 may be used as an individual instrument or connected with a number of other 100 series instruments to the 100 series repeater or to other instruments accepting NMEA 0183 data. -
Page 6: Operation
SPEED SPEED SPEED SPEED TRIP DISTANCE TEMPERATURE TRIP DISTANCE AVERAGE SPEED SPEED TRIP DISTANCE TEMPERATURE TOTAL TOTAL DISTANCE MAXIMUM SPEED SPEED TRIP DISTANCE TEMPERATURE DEPTH DEPTH DEPTH DEPTH TRIP DISTANCE TEMPERATURE TRIP DISTANCE NAVMAN M100 User Manual... -
Page 7: The Depth Alarms
The new unit of measure will be displayed for three seconds. Depth units can be selected in the following order; metres, feet and fathoms. Use the keys to set alarm value. Press the key to exit. DEPTH SPEED NAVMAN M100 User Manual... -
Page 8: Timer Functions
DEPTH 3 SEC DEPTH INCREASE VALUE START DEPTH To reset the count down timer, press and hold keys for three seconds while the countdown timer is displayed. The display will return to the start value selection. NAVMAN M100 User Manual... -
Page 9: Select Speed/Log Units
With the log displayed, press and hold the keys for 3 seconds. Simulation Mode Reset Total Log (Total Distance) The NAVMAN M100 has a simulation mode. With the total log displayed, press and hold the To enter this mode, hold down the key and keys for 15 seconds. -
Page 10: Secondary Functions
TO EXIT ANY TIME If no key is pressed for 10 seconds, the instrument will exit secondary mode and return the display to normal. Changes made to the secondary function being displayed at this time will not be saved. NAVMAN M100 User Manual... -
Page 11: Calibration Procedures
Keel Offset Follow the Secondary Functions chart to reach Temperature Calibration mode. The NAVMAN M100 will normally display the depth of water below the face of the transducer. You may introduce a negative keel offset equal to the distance from the transducer to the bottom of the keel to display the depth of the water below the keel. -
Page 12: Speed Calibration
Enter the simulation mode by holding down the key at power up, When speed is selected in the simulator mode the display will indicate a fixed calibration speed. With the factory default calibration this speed will be 10.0 knots. NAVMAN M100 User Manual... -
Page 13: Troubleshooting Chart
3. Add alternator whine filter to alternator. 4. Replace spark plug wire with resistive type. Simulation Mode If the speed is not changing and reading around 10kts regardless of boat speed then the instrument is in simulation mode. NAVMAN M100 User Manual...
Need help?
Do you have a question about the MULTI 100 and is the answer not in the manual?
Questions and answers