Navman WIND 3150 Installation And Operation Manual

Navman WIND 3150 Installation And Operation Manual

Navman wind 3150 for measuring wind speed and wind angle

Advertisement

NAVMAN
NAVMAN
WIND 3150 Installation and Operation Manual
WIND 3150 Installation and Operation Manual
WIND 3150
Installation and
Operation Manual
English ............. 2
Français ......... 16
Español .......... 29
Português ...... 42
NAVMAN
1
1

Advertisement

Table of Contents
loading

Summary of Contents for Navman WIND 3150

  • Page 1 WIND 3150 Installation and Operation Manual English ..... 2 Français ..16 Español ..29 Português ..42 NAVMAN NAVMAN NAVMAN WIND 3150 Installation and Operation Manual WIND 3150 Installation and Operation Manual...
  • Page 2 Connect the equipment into an output on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced technician for help. A shielded cable must be used when connecting a peripheral to the serial ports. NAVMAN WIND 3150 Installation and Operation Manual...
  • Page 3: Table Of Contents

    9 Systems of several instruments ..............10 9-1 NavBus ........................10 9-2 NMEA ........................10 10 WIND 3150 hardware ..................11 10-1 What comes with your WIND 3150 ................. 11 10-2 Other parts required ....................11 10-3 Accessories ......................11 11 Installation and setup .................. 12 11-1 Installation ........................
  • Page 4: Introduction

    NAVMAN NZ LIMITED DISCLAIMS ALL LIABILITY FOR ANY USE OF THIS PRODUCT IN A WAY THAT MAY CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE THE LAW. This manual represents the WIND 3150 as at the time of printing. Navman NZ Limited reserves the right to make changes to specifications without notice.
  • Page 5: Operation

    (flashes) Masthead unit Vane 2-4 Alarm The WIND 3150 will sound an alarm if the alarm is turned on and the apparent wind speed exceeds the Wind cups alarm value. To turn the alarm on or off and set the...
  • Page 6: Key Reference

    Adjust backlight normal (4 levels or off) operation Set Speed Mode Hold Change wind speed units (M/S or KNOTS) 2 sec Hold (If displaying MAX wind speed) Reset MAX Speed to 0 2 sec NAVMAN WIND 3150 Installation and Operation Manual...
  • Page 7: Display Apparent Or True Wind Speed And Angle

    3 Display apparent or true wind speed and angle Apparent wind speed and angle are the values wind speed and angle. If the WIND 3150 is connected measured by the masthead unit on the boat. True to a boat speed instrument, press...
  • Page 8: Display Wind Angle

    4 Display wind angle The pointer shows wind angle in degrees (0 to 180° If the WIND 3150 is connected to a boat speed port or starboard). To display the numeric wind angle instrument, press to display TRUE or APP...
  • Page 9: Display Maximum Wind Speed

    VMG (velocity made good), is the component of boat speed parallel to the wind. VMG is only available if the WIND 3150 is connected to a boat speed instrument. Note: VMG is always shown in knots. 8 Calibrate wind angle and speed...
  • Page 10: Systems Of Several Instruments

    Wind speed and wind angle group. If you change the backlight in an are output by the WIND 3150 and can be read and instrument in group 0 then no other displayed by the NAVMAN REPEAT 3100 or other instruments are affected.
  • Page 11: Wind 3150 Hardware

    A fuse. Use a 1 A fuse for between one and five instruments. Optional external beepers or lights can be fitted. The WIND 3150 output is switched to ground, 30 V DC and 250 mA maximum. If the beepers and lights require more than 250 mA, fit a relay.
  • Page 12: Installation And Setup

    Fixing nut The WIND 3150 can: 50 mm (2") Drive external beepers or lights for the alarm. Send and receive data from other NAVMAN instruments connected via NavBus. Settings for alarms, units, calibration and backlighting are shared (see section 9-1).
  • Page 13 Take the piece of masthead unit cable that you cut off earlier and connect the cable into the back of the WIND 3150 display unit. Run the cable between the display unit and the cable Power/data wiring...
  • Page 14: Setup

    All settings may be reset to the manufacturer’s To display VMG and true wind speed and Wind speed units ........ knots angle, the WIND 3150 must be connected to a Wind damping ..........2 compatible instrument that outputs boat speed.
  • Page 15: Appendix A - Specifications

    Interference from electrical noise. Review waterproof. Repairs to the unit must only be carried installation. out by a service centre approved by Navman NZ Limited. Users who service the unit themselves will The word SIM flashes on the LCD display or void the warranty.
  • Page 16: Appendix C - How To Contact Us

    16A/A1E, Ba thang hai St. P.O. Box 68 155 Newton, e-mail: info@nuovarade.com District 10, Hochiminh City. Auckland, New Zealand. Website: www.plastimo.it +84 8 86321 59 +64 9 481 0500 e-mail: e-mail: sales@haidangvn.com marine.sales@navman.com Website: www.haidangvn.com Website: www.navman.com NAVMAN WIND 3150 Installation and Operation Manual...
  • Page 17 Made in New Zealand MN000199B NAVMAN Lat 36° 48.404’S NAVMAN NAVMAN WIND 3150 Installation and Operation Manual WIND 3150 Installation and Operation Manual...

Table of Contents