Disassembling The Cutter Unit - Epson Stylus Photo 2100 / 2200 Service Manual

EPSON Stylus PHOTO 2100/2200
When reinstalling the PF Roller Support, hitch the two upper
hooks on the projections of the Under Frame, and insert the two
lower hooks into the notches.
Refer to Figure 4-137, "Removing the PF Roller Support".
Place the Under Driven Roller on the joggle of the PF Roller
Support in advance.
Refer to Figure 4-137, "Removing the PF Roller Support".
DISASSEMBLY AND ASSEMBLY

4.2.18 Disassembling the Cutter Unit

4.2.18.1 Removing the Cutter Sensor
1. Remove the two screws 15) C.B.S 3
(9±1kgf.cm) and two screws (T.B.D) that secure the Cutter Housing.
2. Release the three hooks located on the Cutter Unit bottom.
C.B.S 3x8
Cutter
Housing
C.B.S 3x6
Figure 4-138. Screws That Secure the Cutter Housing
Disassembly
Revision A
×
8 (9±1kgf.cm), two screws 6) C.B.S 3
Screws T.B.D
Hooks
×
6
182