Epson Stylus Photo 2100 / 2200 Service Manual page 148

EPSON Stylus PHOTO 2100/2200
When reinstalling the Printhead, fully take care not to bring the
Nozzle surface into contact with the Carriage Unit.
Refer to Figure 4-62, "Removing the Printhead".
After removing the Printhead (when not changing it), place it so
that the Head surface does not make contact with the desktop.
Refer to Figure 4-62, "Removing the Printhead".
Refer to Figure 4-63 for the way to route the Head FFC Guides.
When reinstalling the Head FFC Guides, fully be careful not to
bend or damage the FFCs. (Especially the two places in the right
photo in Figure 4-63.)
Place the Head FFCs in the return portion on the right and rear
sides of the Carriage.
Refer to the right photo in Figure 4-63, "Routing the Head FFC
Guides".
Figure 4-63. Routing the Head FFC Guides
DISASSEMBLY AND ASSEMBLY
.
Portions to be noted
Carriage Unit top
After removing or changing the Printhead, adjustments are
necessary.
Always make adjustments in the following order.
When the Printhead was removed
1. Head cleaning
2. Head angular adjustment
3. Bi-D adjustment
4. Pixel Shift Adjustment
When the Printhead was changed
1. Ink charge
2. Head ID input
3. Head angular adjustment
4. Bi-D adjustment
5. Pixel Shift Adjustment
6. PG adjustment
Refer to "Chapter 5 Adjustment" for the adjustment procedures.
Disassembly
Revision A
148