Advertisement
Safety Precautions
This vacuum cleaner should be used for normal, dry household dust and dirt. The manufacturer
cannot be held responsible for any damage caused by use or operation of the vacuum contrary
to these instructions. If the vacuum is wrongly operated for a purpose other than that for which
it is intended, no liability can be accepted for any possible damage.
• Do not vacuum areas which contain moisture or water, flammable matter, needles, pins,
razor blades, matches, cigarettes, etc., since they may damage the vacuum or vacuum bag.
• When rewinding the power cord, hold the plug before pressing the cord rewind button to
prevent the cord from whipping.
• Make sure a vacuum bag and filters are always in place.
• This product is equipped with a polarized alternating current line plug (a plug having one
blade wider than the other). This plug fits into the power outlet only one way. This is a safety
feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact an electrician to replace the obsolete outlet. Do not defeat
the safety purpose of the polarized plug.
4
Replacing Vacuum Bag and Filters
Replacing the vacuum bag
Change the vacuum bag when the indicator is RED or
suction power is weak. The dust cover will not close without
a bag in the unit or if the bag is not properly installed.
1. Pull the bag holder straight out to access the bag.
2. Push the latch on the underside of the holder to release
the bag collar.
3. Remove and discard the used bag. NOTE: The
Performance HEPA™ bag cannot be reused.
4. Secure the new bag with the bag collar holder latch. Slide
the tab on the bag holder into the slot on the front of the
bag compartment.
Replacing the secondary filter
1. Open the bag compartment and locate the
filter behind the vacuum bag. For better
access to the secondary filter, remove the
bag holder and bag.
2. Slide filter holder up and out.
3. Remove the used filter and replace it with
a new filter.
4. Slide the filter holder back in place and
replace the bag holder and bag.
Replacing the HEPA filter
1. Locate the HEPA filter inside the bag
compartment near the door hinge.
2. Press the black tab to remove the used
filter and snap in a new filter. NOTE: The
HEPA filter cannot be washed and reused.
5
Advertisement
