Lenovo ThinkServer 1043 Installation And User Manual page 52

Lenovo server installation and user guide
Hide thumbs Also See for ThinkServer 1043:
Table of Contents

Advertisement

d. It is recommended that you replace the battery pack on the battery card assembly annually or after
500 recharging cycles, whichever comes first.
e. The temperature of the battery card assembly is generally 15-20°C (59-68°F) higher than the
ambient temperature during fast charge. Therefore, to complete a fast charge cycle, the ambient
temperature should be lower than 45°C (113°F). If the ambient temperature exceeds 45°C (113°F),
the fast charge cycle will terminate prematurely, thus preventing the battery card assembly from
reaching a fully charged state.
Attention:
• When attaching the battery card assembly to a PCI Express slot, center the Phillips-head screw
driver to avoid damaging the screw head and do not over-tighten the screws as you might damage
the battery card assembly.
• The battery in the battery card assembly must recharge for at least six hours during fast charge
under normal operating conditions.
To install the battery card assembly onto the RAID controller, do the following:
42
ThinkServer Installation and User Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkserver 4010Thinkserver 1044Thinkserver 4011

Table of Contents