Microprocessor Problems - Lenovo ThinkServer 1043 Installation And User Manual

Lenovo server installation and user guide
Hide thumbs Also See for ThinkServer 1043:
Table of Contents

Advertisement

• See the parts listing in the Hardware Maintenance Manual to determine which components are customer
replaceable units (CRUs) and which components are field replaceable units (FRUs).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a trained service technician.
Symptom
The amount of system memory
that is displayed is less than
the amount of installed physical
memory.
Multiple rows of DIMMs in a
branch are identified as failing.

Microprocessor problems

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See the parts listing in the Hardware Maintenance Manual to determine which components are customer
replaceable units (CRUs) and which components are field replaceable units (FRUs).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a trained service technician.
86
ThinkServer Installation and User Guide
Action
1. Make sure that:
• No error LEDs are lit on the operator information panel or on the DIMM.
• Memory mirroring does not account for the discrepancy.
• The memory modules are seated correctly.
• You have installed the correct type of memory.
• If you changed the memory, you updated the memory configuration in the
Setup Utility program.
• All banks of memory are enabled. The server might have automatically
disabled a memory bank when it detected a problem, or a memory bank
might have been manually disabled.
2. Check the POST event log for DIMM error messages:
• If a DIMM was disabled by a systems-management interrupt (SMI), replace
the DIMM.
• If a DIMM was disabled by the user or by POST, run the Setup Utility program
and enable the DIMM.
3. Make sure that there is no memory mismatch when the server is at the minimum
memory configuration.
4. Add one pair of DIMMs at a time, making sure that the DIMMs in each pair
are matching.
5. Reseat the DIMMs.
6. Replace the DIMMs one at a time in the order and restart the server each time.
1. Reseat the DIMMs; then, restart the server.
2. Replace the lowest-numbered DIMMs with identical known good DIMMs;
then, restart the server. Repeat as necessary. If the failures continue after all
identified pairs are replaced, contact a trained service technician for help.
3. Return the removed DIMMs, one pair at a time, to their original connectors,
restarting the server after each pair, until a pair fails. Replace each DIMM in
the failed pair with an identical known good DIMM, restarting the server after
you reinstall each DIMM. Replace the failed DIMM. Repeat these actions until
you have tested all removed DIMMs.
4. (Trained service technician only) Replace the system board.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkserver 4010Thinkserver 1044Thinkserver 4011

Table of Contents