Xerox DocuPrint C3300 DX User Manual page 90

Item
Substitute Tray
mm / inch
Interrupt Print
Print Priority
DefaultPaperSize
90
5 Control Panel Menus
Sets whether to print on paper loaded in another tray when there is no paper left in the
tray selected by the auto tray selection feature.
• [Off] (default)
Select this not to replace paper but display a message prompting you to load paper.
• [Larger Size]
Select this to replace the paper with a larger size paper before printing in 100%
magnification ratio.
• [Closest Size]
Select this to replace the paper with the nearest size paper before printing in 100%
magnification ratio.
• [Bypass Feed]
Select this to print on the paper loaded in the bypass tray.
Note
• These settings will be overridden by requests sent from computers.
Set the unit for the custom paper size to millimeters (mm) or inches (").
• [Millimeters(mm)] (default)
Indicates length in millimeters (mm).
• [Inches (")]
Indicates length in inches (").
Sets whether to interrupt the current print job if the printer receives data from the
scanner while it is printing.
• [On] (default)
Interrupts the current print job.
Temporarily stops receiving the data for the print job. The data that is already
received continues being printed, as soon as the printers buffer memory has enough
space to receive the print data from the scanner, the current print job is interrupted
and the data from the scanner is printed. This means that the data from the scanner
is printed in the middle of the current print job.
• [Off]
Does not interrupt the current print job.
The print data from the scanner is printed after the current print job and any print jobs
incoming from other ports are finished printing.
Limits the number of pages that can be stored in the printer's buffer memory. This
means that the data from the scanner is printed quickly when [Interrupt Print] is set to
[On].
• [Off] (default)
Number of pages is not limited.
When a print job from the scanner interrupts the current print job, print data already in
the printer's buffer memory continues to print until there is enough space for the print
data from the scanner. In this case, it may take a long time to print the print data from
the scanner if each page of the print data already in the buffer memory is small
because many pages need to be printed to open up enough space in the buffer
memory.
• [On]
Number of pages is limited.
The print data from the scanner is printed quickly because the number of pages
stored in the printer's buffer memory is limited. However, this may reduce the
performance of regular printing.
Sets the default of [Paper Size] for the PDF print mode and the reports.
• [A4] (default)
• [8.5 × 11"]
Description