Xerox DocuPrint C3300 DX User Manual page 85

Item
TCP/IP
IP Mode
IPv4
IPsec
Specifies the settings to use the TCP/IP protocol.
Sets the IP (Internet Protocol) version to be used for the communication between the
printer and clients.
• [Dual Stack] (default)
Enables both IPv4 and IPv6 communications.
• [IPv4]
Enables the IPv4 communication.
• [IPv6]
Enables the IPv6 communication.
Note
• To use the IPv6 feature, refer to "Setting the IP Address in IPv6 Mode" (P. 25) or the
online help for CentreWare Internet Services.
Sets the IP address to be used for the IPv4 communication.
[Get IP Address]
Sets whether to automatically or manually retrieve the IP address.
• [DHCP / Autonet] (default)
Automatically sets the IP address.
• [BOOTP]
Uses BOOTP to set the IP address automatically.
• [RARP]
Uses RARP to set the IP address automatically.
• [DHCP]
Uses DHCP to set the IP address automatically.
• [Panel]
Sets the IP address manually by entering it on the control panel.
[IP Address]/[Subnet Mask]/[Gateway Address]
Allows you to verify or manually enter the IP address.
Enter the IP address in the format of:
xxx.xxx.xxx.xxx
For IP or gateway addresses, xxx can be any number between 0 and 255. However, the
first xxx cannot be 127 or a number between 224 and 255.
For subnet masks, each xxx must be one of the following numbers:
0, 128, 192, 224, 240, 248, 252, 254, and 255.
Important
• To set addresses manually, set [Get IP Address] to [Panel].
• IP addresses are managed in the entire network. An incorrect IP address may affect
the whole network. For the addresses you need to set manually, consult your network
administrator.
Disables the IPsec feature.
Enabling the IPsec feature allows data encryption between the printer and clients over a
network.
Note
• To enable the IPsec feature, configure the settings on CentreWare Internet Services.
For more information, refer to the online help for CentreWare Internet Services.
• [IPsec] does not appear on the model available in China.
Description
5.2 Description of Menu Items
85