Panasonic Lumix DMC-G6 Owner's Manual page 340

Others
Wi-Fi function
It cannot connect to the wireless LAN. Radio waves get disconnected.
•
Use within the communication range of the wireless LAN network.
•
Connection types and security setting methods are different depending on the wireless access
point.
> Refer to the operating instructions of the wireless access point.
•
When the radio waves are interrupted, the condition may improve by moving the location or
changing the angle of the wireless access point.
•
It may not automatically connect when the network SSID of the wireless access point is set not
to broadcast.
> Set the network SSID of the wireless access point to broadcast.
•
Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
operated nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently away
from the device.
•
Is the 5 GHz/2.4 GHz switchable wireless access point connected to other equipment using
the 5 GHz band?
> The use of a wireless access point that can use 5 GHz/2.4 GHz simultaneously is
recommended. It cannot be used simultaneously with this camera if it is not compatible.
•
When the battery indicator is flashing red, the connection with other equipment may not start or
the connection may be disrupted. (A message such as [Communication error] is displayed.)
Wireless access point is not displayed. Or it cannot be connected.
•
Check if the wireless access point to connect is in operating state.
•
The camera may not display or connect to a wireless access point depending on the radio
wave condition.
> Perform the connection closer to the wireless access point.
•
It may not display even if the radio waves exist depending on the setting of the wireless access
point.
> Check the settings of the wireless access point.
•
The wireless access point may not be found depending on the radio wave condition.
> Perform the [Manual Connection].
•
Is the network SSID of the wireless access point set not to broadcast?
> It may not be detected when it is set not to broadcast. Enter and set the network SSID.
(P282)
•
Try the following:
–
Move this unit closer to the wireless access point.
–
Remove the obstacles between this unit and the wireless access point.
–
Change the direction of this unit.
(P282)
340