Input Channel; Access Main Menu; Storing Channels Manually - Philips VR20D/07 User Manual

58
EN
NUMBER
MENU

Storing Channels Manually

Store channels that were not stored during Auto Set Up (
8), Preset Download (

ACCESS MAIN MENU

1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
tion screen appears.
SELECT POSITION
3
@ #
Press % fi
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The
Manual Channel Set
screen appears.
+ +
1 2 3
- -
4 5 6
7 8 9
CLEAR
0
PROG. +
PROG. –
+ +
-
-
OK
pg. 10) or Auto Channel Set (
#
. The Confirma-
(Ex.) To store in position 6.
PR CH ID
01 26 BBC1 08
02 33 BBC2 09
03 23 ITV
04 30 CH4
05 37 CH5
06 –––– 13
07 –––– 14
[ 5 ∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SUBSIDIARY SETTINGS (cont.)
SELECT BAND
4
Press % fi to change the
band between CH (regular)
and CC (cable), then
press

INPUT CHANNEL

5
Press the NUMBER keys to input the channel number you
want to store.
ENTER NEW CHANNEL
INFORMATION
pg.
6
Press OK and the Confirmation screen appears.
pg. 56).
CLOSE CONFIRMATION
SCREEN
7
Press MENU.
ATTENTION
Guide Program numbers are not set when channels are
PR CH ID
––––
stored manually. If an attempt is made at timer program-
––––
ming with the VIDEO Plus+ system in this state, the
10 ––––
11 –––– "GUIDE PROG SET" screen appears; set the Guide Program
12 ––––
numbers on this screen.
––––
–––– Guide Program Number Set" on pg. 31.
Or perform "Guide Program Number Set" (
#
.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Input "0" before any single number entries.
To input the registered station name (ID –
#
press until "----" (ID setting) begins blinking, then
press % fi.
For fine tuning adjustment, press
blinking, then press % fi. While tuning, "+" or "–"
appears.
When storing a channel that sends scrambled
#
broadcasts, press until "OFF" (Decoder setting)
blinks, then press %fi to set "DECODER" to "ON"
("OFF" is the default setting).
When "AV2 SELECT" is set to "AV2" or "SAT", the
"DECODER" setting cannot be changed (
Repeat steps 3 through 6 as necessary.
To change positions, see "Change Station Channel
Position" ( pg. 59).
If you wish to set station names other than the ones
registered in your recorder,
page 61.
"ATTENTION – Regarding
PR CH ID FINE DECODER
06 CH01 – – – – +/– OFF
[ 5 ∞ ] : SELECT
] : CURSOR +=
[
: OK
[MENU] : EXIT
pg. 62),
#
until "+/–" begins
pg. 50).
"Set Stations (B)" on
pg. 55).