Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alliance Laundry Systems 201932R5
Summary of Contents for Alliance Laundry Systems 201932R5
- Page 1 Automatic Washers Metered and Nonmetered Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com. W446I Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 201932R5 www.comlaundry.com August 2012...
- Page 3 W022 IMPORTANT: Read the complete INSTALLATION/OPERATION INSTRUCTIONS before using the washer. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932...
-
Page 4: Table Of Contents
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... - Page 5 Replacing Hoses................33 Filter Screens ................... 33 Reinstallation of Shipping Materials ..........33 Motor Overload Protector..............33 Troubleshooting .................. 34 Contact Information................36 Installer Checklist..............Back Cover 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 6: Safety Information
6. To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the washer to the electrical power source. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... - Page 7 If the washtub does not stop when the lid is opened, remove the washer from use and call the service person. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932...
-
Page 8: Installation
TLW2051N Pilot Hole 21.56 in. (54.76 cm) 0.44 in. 25.63 in. (65.1 cm) 26 in. (66.04 cm) (1.12 cm) 28 in. (71.12 cm) TLW2050N NONMETERED MODELS TLW2050N © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 9: Before You Start
IMPORTANT: Install dryer before washer. This allows room for attaching exhaust duct. TLW2052N TLW2052N Shipping Brace Shipping Plug Cardboard Base Figure 2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 10: Step 2: Wipe Out Inside Of Washtub
(liters per (liters per (liters per minute) minute) minute) 7.15 (9.1) (17.0) (27.1) (13.2) (23.5) (34.8) Table 1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 11: Connecting Hoses
All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 12: Step 4: Connect Drain Hose To Drain Receptacle
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 13: Step 5: Position And Level The Washer
Place rubber cups on all four leveling legs. Place a level on the cabinet top and check if the washer is level from side to side and front to back. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 14: Step 6: Plug In The Washer
110/120 Volts AC (alternating current) 15 Amps. Refer to Figure 10 to determine correct polarity of the wall receptacle. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 15: Step 7: Add Water To The Washer
NOTE: The agitator should not be removed except for service. The washtub is designed to be self- cleaning. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 16: Vending
6. Install extension spring in bracket hole and hole in upper arm of lever. Refer to Figure 14. 7. Bend loops closed after installation. 8. Check to make sure the lever swings freely. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 17: Slide Extension Assembly - Models Starting Serial No. 1211
NOTE: If more switch down-force is required, install lever with arm that has two stars facing down to provide additional switch travel. TLW2090N TLW2090N Lever Off Switch Figure 16 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... - Page 18 "A" facing up and toward extension bracket and lever assembly. Refer to Figure 19. Extension Bracket and Coin Slide Bracket - Lever Assembly Letter "A" TLW2157N Figure 21 TLW2155N Figure 19 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932...
-
Page 19: Models Prepped For Card Reader
4. Check to make sure coin slide is operating properly by inserting coins and starting a cycle. The IN USE light will turn on, or flash if it is already on, to indicate proper operation. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 20: Additional Washer Security
2. Remove two screws holding control panel to control hood. 3. Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 21: Operation
If desired, fabric softener may be added to rinse water Figure 25 when RINSE light comes on. Step 3: Close Lid Washer will not operate with lid open. W395I W394I Figure 24 Figure 26 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 22: Step 4: Set Wash Temperature And Fabric/Cycle Selector
Settings with asterisk (*) are Energy Saving Cycles. TLW2045N Figure 27 TWO SPEED PERM PRESS WASHERS DELICATE NORMAL DELICATE NORMAL PERM PRESS FABRIC SELECTOR TLW2083N TLW2083N Figure 29 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 23: Step 5: Start Washer
W092 The washer will stop (pause) shortly before the first TLW2048N spin and final spin. Figure 31 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 24: Control Modes
The control enters End of Cycle Mode when a cycle is complete. The IN USE LED will be off. The control will remain in this mode until the lid is opened or vend has been satisfied. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 25: Rapid Advance
• From final spin, cycle will advance to End of Cycle Mode. • Open lid to clear End of Cycle Mode and return to Ready Mode. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 26: Operation Instructions For Electronic Display Control Washers
If desired, fabric softener may be added to rinse water W392I when RINSE light comes on. Figure 33 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 32 H338I Figure 34 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 27: Step 4: Choose Small Load, If Desired
LID MUST BE CLOSED TO START Step 5: Set Fabric Selector WASHER. Push touchpad for NORMAL, PERM PRESS or DELICATES. Light indicates selection. W387I W338IE0B Figure 38 Figure 36 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 28: Indicator Lights
It will light at the start of the cycle and remain lit until the cycle is completed. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 29: Operation Instructions For Mdc Washers
If desired, fabric softener may be added to rinse water when RINSE light comes on. W392I Figure 40 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 39 H338I Figure 41 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 30: Step 4: Choose Small Load, If Desired
Step 5: Set Fabric Selector and Wash Insert card into opening. Temperature Push touchpad for NORMAL/HOT, NORMAL/ WARM, PERM PRESS/WARM or DELICATES/ COLD. Light indicates selection. FLW1920N FLW1920N Figure 43 DRY1927N Figure 45 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 31: Step 7: Start Washer
RINSE is lit at the beginning of the Rinse cycle and will remain lit until the cycle is complete. SPIN SPIN is lit for all Spin cycles. FLW1923N Figure 46 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 32: Operation Instructions For Netmaster Washers
If desired, fabric softener may be added to rinse water when RINSE light comes on. W392I Figure 48 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 47 H338I Figure 49 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 33: Step 4: Choose Small Load, If Desired
The SMALL LOAD indicator light will be off. Push touchpad for HOT, WARM or COLD. Light indicates selection. W525I W525I Figure 52 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 34: Step 7: Insert Money Or Card
REMOVE CARD (Card Models Only) REMOVE CARD flashes after the START pad has been pressed and the vend has been deducted from the card. M343I Figure 54 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 35: Maintenance
If the overload protector stops motor again, remove necessary. the washer from use and call the service person to Order filter screen Part No. F270300 from the nearest correct the problem. authorized parts distributor. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 36: Troubleshooting
Check the laundry room fuse or circuit breaker. • • The motor overload protector may have stopped the cycle. It will reset itself in two or three minutes and restart the washer automatically. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... - Page 37 “H” on the valve bracket) and cold faucet is connected to cold mixing valve (indicated with “C” on the valve bracket). • Make sure laundry room water heater is adjusted properly. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932...
-
Page 38: Contact Information
If replacement parts are required, contact the source from where you purchased your washer or call (920) 748-3950 for the name and address of the nearest authorized parts distributor. W138P W138P Nameplate Figure 57 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932... -
Page 40: Installer Checklist
Fill COLD Hoses. TLW1988N TLW1988N TLW2056N TLW2056N CHECK CHECK • Check Lid Switch. • Connect Drain Hose to Drain Receptacle. W294IE0A W294IE0A CHECK CHECK TLW1974N TLW1974N © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the 201932R5 and is the answer not in the manual?
Questions and answers