Troubleshooting - Haier ESD300 User Manual

English

TROUBLESHOOTING

Try the solutions suggested here first and possibly avoid the cost of a service
call...
DISHWASHER IS NOT OPERATING PROPERLY
• Dishwasher does not run or stops during a cycle
Is the door closed tightly and latched?
Is the right cycle selected? Refer to the Cycle Selection charts.
Is there power to the dishwasher? Has a household fuse blown or circuit
breaker tripped?
Has the motor stopped due to an overload? The motor automatically resets
itself within a few minutes. If it does not restart, call for service.
Is the water shut-off valve ( If installed ) turned on?
It is normal for certain cycles to repeatedly pause for several seconds during
the main wash.
• Dishwasher will not fill
Is the overfill protection float able to move up and down freely? Press down to
release.
• Dishwasher seems to run too long
Is the water supplied to the dishwasher hot enough? The dishwasher runs
longer while heating water Refer to the "Dishwasher Performance Tips" section.
A delay automatically occurs in some wash and rinse cycles until the water
reaches the proper temperature.
• Water remains in the dishwasher
Is the cycle complete?
• Detergent remains in the covered section of the dispenser
Is the cycle complete?
Is the detergent lump-free? Replace detergent if necessary.
• Water residue on the front of the access panel
Was too much detergent used? Refer to the "Detergent Dispenser" section.
Is the brand of detergent making excess foam? Try a different brand to reduce
foaming and eliminate buildup.
• Odor in the dishwasher
Are dishes washed only every 2 or 3 days? Run a rinse cycle once or twice a
day until you have a full load.
Does the dishwasher have a new plastic smell? Run a vinegar rinse as
described in "Spotting and filming on dishes" later in this troubleshooting
guide.
• Condensation on the kitchen counter ( built-in models )
Is the dishwasher aligned with the countertop? Moisture from the vent in the
dishwasher console can form on the counter. Refer to the lnstallation
Instructions for more information.
27