C H A P T E R
3
Operating Your TV
Once you have connected your TV/VCR to an antenna or cable system,
plugged the TV in, and put batteries in the remote, you are ready to use
the TV. The first thing you should do is program your TV/VCR so it
memorizes all of available channels.
Turning Your TV/VCR On
Programming Your TV/VCR's Channel Memory
Your TV/VCR's memory determines the channels that are available
using the
CH
with the number buttons, but not with the
steps to program your TV/VCR's memory:
1. With the TV on, press the MENU button until "Set-Up menu will be displayed.
2. Use the
CH
button to select Air or Cable . If you connected an antenna to your
TV/VCR, select Air ; If you connected a cable system, select Cable .
3. Use the
CH
VOL
button to enter the Memorize Channels process.
4. Press the MENU button to return to Set-Up menu.
5. Press the MENU button to return to normal TV viewing.
Your TV/VCR's channel memory will not be affected by a power outage.
You will not need to re-program the memory unless you change the type
of cable or antenna connected to your TV/VCR.
1. To turn your TV/VCR, press the POWER button on
the remote control. You can also use the POWER
button on the front panel. Make sure your TV is
plugged in before you try to turn it on.
buttons. If a channel is not in memory, you can tune to it
buttons to select Reception , then use the VOL
buttons to select Memorize Channels , then use the
CH
buttons. Follow these
Chapter 3 : Operating Your TV
13