Chapter 2 : Connecting An Antenna Or Cable To Your Tv/Vcr; Connecting An Antenna - TruTech DW13CTT Instruction Manual

C H A P T E R 2
Connecting an Antenna or Cable to Your TV/VCR
Your TV/VCR will provide you with the best performance if you connect
it to an external antenna or cable system. Follow the directions below
make this connection. Please note that you will normally only have to
make one of the connections shown below, not all of them.
All connections will be made to the antenna terminal on the back of your
TV/VCR. The antenna terminal is a silver metal post partially surround-
ed by two plastic tabs. For help in locating the antenna terminal, see
"Your TV/VCR's Back Panel on page 5.
There is no antenna provided with your TV/VCR.

Connecting an Antenna

If your antenna ends in a pair of 300 ohm twin leads, you must use
a 300-ohm/75-ohm adaptor. (An adaptor is included with your 13"
TV/VCR.) Place the leads underneath the screws on the adaptor, tight-
en the screws, then press the adaptor onto the antenna terminal on
the back of the TV/VCR.
(The rod antenna need to be purchased seperately.)
If your antenna ends in a single
coaxial lead, simply press or screw
the cable onto the antenna terminal
on the back of your TV/VCR.

Chapter 2 : Connecting an Antenna or Cable to Your TV/VCR

9