About This Guide; For More Information; Technician Notes; Disassembly - Packard Bell iPower GX Disassembly Manual

About This Guide

This guide contains systematic disassembly instructions for the Packard Bell iPower GX. The
instructions are illustrated where necessary with images of the part that is being disassembled.
Packard Bell B.V. reserves the right to make changes to the iPower GX without notice.

For More Information

For more information about the Packard Bell iPower GX, visit Packard Bell's support web site at
www.packardbell.com. The support web site also has links to additional Packard Bell
documentation and detailed product specifications.

Technician Notes

Only technicians authorized by Packard Bell B.V. should attempt to repair this equipment. All
troubleshooting and repair procedures are detailed to allow only subassembly/module level repair.
Because of the complexity of the individual boards and subassemblies, no one should attempt to
make repairs at the component level or to make modifications to any printed wiring board.
Improper repairs can create a safety hazard. Any indication of component replacement or printed
wiring board modifications may void any warranty or exchange allowances.

Disassembly

When disassembling the system unit, follow these general rules:
Turn OFF the power to the system and all peripherals using the power button.
Unplug the AC adapter and all power and signal cables from the system.
Remove any SD/MMC card, ExpressCard or dummy card from the computer.
Do not disassemble the system into parts that are smaller than those specified in the
instructions.
Label all removed connectors; note where the connector goes and in what position it was
installed.
The screws for the different components vary in size. Group the screws with the
corresponding components during the disassembly process to avoid mismatch when
putting back the components.
Observe the order of the disassembly steps to prevent damaging any of the hardware
components.
Some of the procedures in this guide involve removing tape that holds cables or
components. If the existing tape cannot be reused, replace it with the same type
(conductivity) of tape. Do not use cellophane tape!

Reassembly

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and
screws are returned to their proper positions. Check that no tools or any loose parts have been left
inside the casing. Check that everything is properly installed and tightened.

Required Tools

To disassemble the computer, you need the following tools:
Wrist grounding strap and conductive mat for preventing electrostatic discharge.
Small Phillips screwdriver.
Small flat screwdriver.
Scribe or non-marring tool.
Packard Bell iPower GX Disassembly Manual
2