Furthermore, the screws that are removed are shown next to the image of the parts themselves. Packard Bell reserves the right to make changes to the EasyNote B3 chassis without notice. Technician Notes Only technicians authorized by NEC Computers International B.V. should attempt to repair this equipment.
Non personal injury. Always return a defective power avviare il sistema senza aver prima messo supply to your dealer. a posto il coperchio. Packard Bell EasyNote B3 Disassembly Manual...
4. Remove the screws in the exact order shown. 5. Lift out the heat sink assembly. 6. Lift the lever on the CPU socket and lift out the CPU. Packard Bell EasyNote B3 Disassembly Manual...
Picture 2. Power Cable of Heat Sink Assembly Picture 3. Heat Sink Assembly Screws WiFi LAN Adapter (Mini PCI) To remove the Wireless LAN Adapter (mini PCI), perform the following steps: 1. Remove the bottom cover (5 screws marked B on Picture 2.
Picture 4. WLAN Mini PCI Adapter and Antenna Note: The WLAN card has 2 connectors: MAIN and AUX. Please be sure to connect the antenna to the MAIN connector when re-assembling the WLAN card! Keyboard To remove the keyboard, perform the following steps: 1.
Picture 7. Keyboard Flat Cable Speakers To remove the speakers, perform the following steps: 1. Remove the keyboard cover as described in the chapter Keyboard. 2. Disconnect the speaker cables as shown in Picture Picture 9, and Picture 3. Remove the screws securing the speaker (2 screws per speaker). 4.
Picture 10. Right Speaker Connector LCD Screen Assembly To remove the LCD screen assembly, perform the following steps: 1. Remove the keyboard top cover as described in the chapter Keyboard. 2. Remove the LCD hinge covers; these are ‘ clicked’ in place on the backside of the notebook.
Page 10
Picture 11. Bottom Base Screws Picture 12. Glide Pad Flat Cable Picture 13. Main Board Screws Under Keyboard Cover...
Picture 14. Main Board Screws Translation Board The translation board is a small PCB with a USB, VGA-Out and AC adapter connector. To remove it, perform the following steps: 1. Perform all steps to remove the main board (see chapter Main Board).
Picture 15. LCD Switch LCD Screen Disassembly LCD Lid Assembly To remove the LCD lid assembly, perform the following steps: 1. Remove the keyboard top cover as described above. 2. Remove the LCD hinge covers; these are ‘ clicked’ in place on the backside of the notebook.
Picture 16. LCD Bezel Inverter Board To remove the inverter board, perform the following steps: 1. Unplug the cable on the inverter board. 2. Remove the screw (screw A in Picture 17). 3. Take away the inverter board. Picture 17. LCD Assembly Without Bezel LCD Panel To remove the LCD panel, perform the following steps: 1.
3. Gently lift out the LCD panel. 4. Remove the remaining 2 screws on each side of the LCD panel to remove the brackets. Wireless Antenna To remove the wireless antenna, perform the following steps: 1. After removing the LCD panel, remove the tape holding the antenna. 2.