Removing The Heat Sink Fan (Hsf) Assembly; Remove The Wall Mount Plate By Following The Procedure Described - Packard Bell oneTwo M3350 Service Manual

5. Remove the inverter board.
A circuit board that is >10 cm
above image. Follow local regulations for disposing this type of circuit board.

Removing the Heat Sink Fan (HSF) Assembly

1. Remove the wall mount plate by following the procedure described on page 35.
2. Disconnect the HSF cable from its mainboard connector.
Packard Bell oneTwo M3350 / oneTwo M3351 / oneTwo L5350 / oneTwo L5351 Service Guide
2
has been highlighted with a yellow rectangle as shown in the
43