Frigidaire Grill with Electronic Ignition Use & Care Manual page 16

Using the Rotisserie & Side Burners
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the rotisserie
counterclockwise to the "HIGH" position. Wait 5 seconds.
Then press and hold the electronic igniter button. You should
Hear a snapping sound. If the burner does not light in
4 seconds, turn the control knob to "OFF" and wait 5 minutes
before trying again. Once lit, turn the control knob to the
desired setting. (See Fig. 10)
(If the igniter does not function, the burner can be lit by holding
a lit match with lighting rod to the burner while the Control knob
is turned counterclockwise to "HIGH".)
(See Fig. 11)
NOTE: After the first use the stainless steel around the
burner will darken. This is a normal reaction of premium
stainless steel to heat and is not a defect. The infrared
panel will also darken after initial use. This is also a normal
occurrence.
NOTE: Do not operate the main
burners and infrared back burner
!
at the same time. This can cause
warping of the roll top grill hood.
SIDE BURNER LIGHTING
Push and turn the control knob to the "HIGH" position and
immediately press and hold the electronic igniter button. You'll
hear a snapping sound. It may be necessary to hold the
electronic starter button for about 4 seconds. If the burner does
not light in 4 seconds, turn the knob to the "OFF" position and
wait 5 minutes before trying again. Repeat above steps to light
remaining burners. (See Fig. 12)
MATCH LIGHTING OF THE BURNER
If by chance the electronic igniter does not light the burner, the burner may be lit with a match and lighting rod.
Keep your face as far away from the burner as possible and place a lit, long stem match through the spaces in the
grate to the ports of the burner. Position the match near the burner ports and push and turn the control knob to the
"HIGH" position.
24
Fig. 10
Fig. 11
Fig. 12