Point-To-Point Protocol Over Atm - Siemens 5935 User Manual

SIEMENS 5930/5935 Business Gateway
User's Guide

Point-to-Point Protocol over ATM

If you selected Point-to-Point Protocol over ATM from the Wan Interface page, the Point-to-Point Protocol
page is displayed when you click Next.
To configure Point-to-Point Protocol:
1. Enter PPP User Name and Password to use for authentication when establishing a WAN connection using
PPP protocol.
2. Select one or more of the following PPP Networking options:
•
Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
3. IP Routing Enabled:
Route all IP traffic to remote hosts.
4. If you enabled IP routing, optionally select one or more of the following:
•
NAT Enabled:
Network Address Translation (NAT) allows multiple workstations on your LAN to share a single, public
IP address. All outgoing traffic appears to originate from the router's IP address.
•
Block Net BIOS Traffic:
NetBIOS is a PC networking protocol that can keep network connections open inadvertently. To avoid
excess connection charges, such traffic should be blocked on any metered network service.
5. Click Next. This displays the
SIEMENS
Dynamic Host Configuration Protocol
Chapter 3 Easy Setup
page.
Select Protocol
22