Waking Up The System - TANDBERG C20 PLUS User Manual

Getting started
What's in this guide? Getting started

Waking up the system

To make a call you need to wake up the system from standby.
However, if someone calls you, the system will wake up by itself.
• To wake up the system just pick up the TRCV remote control or
press any key. You may have to point the remote control towards
the system to make sure it discovers you.
• The system will now display the wallpaper.
• The dial-in address (H.323 Alias ID) or dial-in number (H.323 Alias
E164) of your system is displayed in the upper left corner. If you
have questions about the dial-in address or number, contact your
system administrator.
• The screen will also indicate if there are any calls you have missed.
D1458203 USER GUIDE Profile Series, Codec C Series, Quick Set C20 / C20 Plus (TC3)—March 2010
Making calls Using the phone book
After wake-up, the screen will typically look like this:
The dial-in address (H.323 Alias ID) or dial-in
number (H.323 Alias E164) of your system is
displayed in the upper left corner.
If the system fails to respond to the remote control or to incoming calls, make sure that:
• The system is connected to line voltage.
• The remote control has working batteries.
• The internal cables, such as the monitor cable and/or the camera cables are properly
connected, see the installation sheet for details, if needed.
4
In-call features
alice.wonderland@mycompany.com
Softkeys (described on the following pages).
Advanced settings
Date and time of day.