Starting Ibm Bios Setup Utility - IBM ThinkPad R50 Series Service And Troubleshooting Manual

Starting IBM BIOS Setup Utility

Starting IBM BIOS Setup Utility

Your computer provides a program, called IBM BIOS Setup Utility, that
enables you to select various setup parameters.
Config: Set the configuration of your computer.
Date/Time: Set the date and time.
Security: Set security features.
Startup: Set the startup device.
Restart: Restart the system.
Note: You can set many of these parameters more easily by using the
ThinkPad Configuration Program.
To start IBM BIOS Setup Utility, do as follows:
1. To protect yourself against accidental loss of data, back up your computer
registry. For details, refer to the on-board help.
2. Remove any diskette from the diskette drive, and then turn off the
computer.
3. Turn on the computer; then, while the "To interrupt normal startup, press
the blue Access IBM button" message is displayed at the lower-left of the
screen, press the Access IBM button.
4. Double-click Start setup utility.
If you have set a supervisor password, the IBM BIOS Setup Utility menu
appears after you enter the password. You can start the utility by pressing
Enter instead of entering the supervisor password; however, you cannot
change the parameters that are protected by the supervisor password. For
more information, refer to the on-board help.
5. Using the cursor keys, move to an item you want to change. When the
item you want is highlighted, press Enter. A submenu is displayed.
6. Change the items you wish to change. To change the value of an item, use
the F5 or F6 key. If the item has a submenu, you can display it by pressing
Enter.
7. Press F3 or Esc to exit from the submenu. If you are in a nested submenu,
press Esc repeatedly until you reach the IBM BIOS Setup Utility menu.
Note: If you need to restore the settings to their original state as of the
time of purchase, press F9 key to load the default settings. You can also
select an option in the Restart submenu to load the default settings or
discard the changes.
8. Select Restart; then press Enter. Move the cursor to the option you want
for restarting your computer; then press Enter. Your computer restarts.
30
®
ThinkPad R50 Series Service and Troubleshooting Guide