Wine Rack Removal And Installation - U-Line 3000 SERIES Use And Care Manual

Adjusting Interior Shelves
Models equipped with glass shelves have an adjustable mounting
system. To adjust or simply remove shelves for cleaning, follow the
instructions below.
Removing / Installing Glass Shelves.
1. Remove all product from shelf.
2. Coming from underneath the shelf, lift both the front and rear of
the glass.
3. Carefully slide shelf out of unit being careful not to scratch the
interior liner.
4. Installation is the reverse of removal.
Adjusting shelf height.
Shelf height may be adjusted to accommodate a broad range of
product. To alter your shelf spacing follow the instructions below.
1. Remove the 4 Shelf retention clips from the shelf slots.
2. Move retention clips as a group to the desired shelf height.
3. Insert shelf clip into the slot of the desired shelf height. Be
certain shelf clip is fully seated into shelf clip slot.
WARNING
Clips MUST be installed with the ribbed side up. Failure
to do so may result in shelf or unit damage.
Clip Slots
IMPORTANT IMPORTANT
All 4 shelf clips for each shelf must be installed at the
same height for shelf stability.
4. reinstall shelf.
Cleaning Shelves
Shelves may be cleaned in a soapy warm water solution. A general
household disinfectant may be used if necessary. Be sure to
completely dry your shelf before reinstalling
12

Wine Rack Removal and Installation

Wine cabinets are equipped with full extension wine racks. To
remove your wine racks for cleaning follow the instructions below.
To remove a rack from the cabinet:
1. Remove any bottles stored on the rack.
2. Grasp the end of the rack, and gently slide it out until it stops.
3. Press the left rack release lever down. At the same time, lift the
matching right rack release lever up. Pull the rack out until it is
free of the tracks and the cabinet.
Do not remove the track rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks in the
cabinet. Ensure an even track engagement on both sides by
gently pushing the rack into the cabinet until it stops.
2. Before reloading the rack, ensure proper movement of the
travel stops in the left and right track rails by pulling the rack out
gently until it stops.
Cleaning Wine Racks.
3. Saturate a soft cloth with a soapy, warm water, solution.
4. Wring excess water from cloth and wipe racks down.
The outside of the wine racks are greased. This white
lithium grease helps provide smooth operation of the slide
mechanism. It is important not to remove grease.
U-Line 3000 Series Maintenance
IMPORTANT IMPORTANT
IMPORTANT IMPORTANT