Adjusting Grille; Adjusting Interior Shelves; Wine Rack Removal And Installation - U-Line U-3018WCOL-00 Use & Care Manual

Adjusting Grille

The grille has an automatic vertical plane adjustment and can also
be adjusted on its horizontal plane as well. To adjust your grille to
match your surrounding cabinetry follow the instructions below.
1. Loosen, but do not remove, the lock screws on the inside of
the grille rails. Lock screws are located on the inside of each
grille rail.
2. Pull grille out to desired position and secure lock screws.
3. The grille skirt may be manually adjusted to the height of your
floor. Simply raise or lower the skirt as needed.

Adjusting Interior Shelves

Models equipped with glass shelves have an adjustable mounting
system. To adjust or simply remove shelves for cleaning, follow the
instructions below.
Removing / Installing Glass Shelves.
1. Remove all product from shelf.
2. Coming from underneath the shelf, lift both the front and rear of
the glass.
3. Carefully slide shelf out of unit being careful not to scratch the
interior liner.
4. Installation is the reverse of removal.
Adjusting shelf height.
Shelf height may be adjusted to accommodate a broad range of
product. To alter your shelf spacing follow the instructions below.
1. Remove the 4 Shelf clips from the shelf clip holes.
2. Move shelf clips as a group to the desired shelf height.
3. Insert shelf clips into the holes of the desired shelf height. Be
certain shelf clip is fully seated into shelf clip hole.
Clip Holes
WARNING
Clips MUST be installed with the ribbed side down.
Failure to do so may result in shelf or unit damage.
11
All 4 shelf clips for each shelf must be installed at the
same height for shelf stability.
4. Reinstall shelf.
Cleaning Shelves
Shelves may be cleaned in a soapy warm water solution. A general
household disinfectant may be used if necessary. Be sure to
Grille
completely dry your shelf before reinstalling.
Skirt

Wine Rack Removal and Installation

Wine cabinets are equipped with full extension wine racks. To
remove your wine racks for cleaning follow the instructions below.
To remove a rack from the cabinet:
1. Remove any bottles stored on the rack.
2. Grasp the end of the rack, and gently slide it out until it stops.
3. The release lever are located on the inside of the rack rails.
Press the left rack release lever down. At the same time, lift the
matching right rack release lever up. Pull the rack out until it is
free of the tracks and the cabinet.
Do not remove the track rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks in the
cabinet. Ensure an even track engagement on both sides by
gently pushing the rack into the cabinet until it stops.
2. Before reloading the rack, ensure proper movement of the
travel stops in the left and right track rails by pulling the rack out
gently until it stops.
Cleaning Wine Racks.
3. Saturate a soft cloth with a soapy, warm water, solution.
4. Wring excess water from cloth and wipe racks down.
The wine racks are greased. This white lithium grease
helps provide smooth operation of the slide mechanism. It
U-Line 3000 Series Maintenance
IMPORTANT IMPORTANT
IMPORTANT IMPORTANT
IMPORTANT IMPORTANT
is important not to remove grease.