3000 Series Doors; Door Alignment And Adjustment - U-Line 3000 SERIES Use And Care Manual

7 3000 Series Doors

Door Alignment and Adjustment

Align and adjust the door if it is not level, or is not sealing properly.
If the door is not sealed the unit may not cool properly, or
excessive frost or condensation may form in the interior.
IMPORTANT IMPORTANT
Properly aligned, the door's gasket should be firmly in
contact with the cabinet all the way around the door (no
gaps). Carefully examine the door's gasket to assure that
it is firmly in contact with the cabinet. Also make sure the
door gasket is not pinched on the hinge side of the door.
WARNING
• Do not attempt to use the door to raise or pivot
your unit. This would put excessive stress on the hinge
system.
• Pay special attention to the Cable Arm. Make sure not
to over extend or damage it during door alignment
Stainless Models (Removing Wrap)
1. Open door completely
2. Use a short phillips head screw driver to remove stainless steel
wrap screws from bottom of the door.
3. Remove the two wrap screws from the bottom of the stainless
steel door wrap.
Wrap Screws
Cable Arm
4. Gently pull bottom of wrap away from door.
5. The Wrap hinges on top of the door. Carefully pull wrap away
and then up. See Below.
6. Remove cable from display by
pressing the release pin on the
cable connector.
Alignment and Adjustment
1. Using a T-25 Torx Bit, loosen each pair of torx head screws on
both the upper and lower hinge plate.
2. Square and align door as necessary
3. Tighten Torx head screws on hinge
4. If necessary re-install Stainless steel wrap.
U-Line 3000 Series Door Alignment
Step 2
Door Top
Step 1
Door Bottom
T-25 Torx Screw
T-25 Torx Screw
Press Tab Down
14