TurboChef TORNADO Quick Manual page 2

Option 1: Tornado/Tornado
Option 3: Tornado/C3
Option 5: HHB/C3
Option 7: Encore/Encore
Option 2: C3/C3
Option 4: HHB/HHB
Option 6: Tornado/HHB
Stacking Tornado, C3, High h Batch, and
Encore Ovens
1. Ensure the surface that will hold the stacked ovens can support the total weight
plus the intended use. Each High h Batch: 157 lb. (71 kg), each Tornado: 190 lb.
(86 kg), each C3: 255 lb. (116 kg), each Encore: 190 lb. (86 kg) each.
2. Allow each oven adequate time to cool and then unplug.
3. If stacking the ovens on an oven cart, ensure the bottom oven is bolted to
the cart and the wheels are locked (see reverse side of sheet).
4. Attach the stacking bracket* to the back of the bottom oven:
a. Remove the screws marked with white arrows in the adjacent figures.
b. Align the holes on the stacking bracket with the holes on the oven and
reinstall the screws. Be sure to orient the bracket as shown in the
adjacent figures.
* Options 1-3 use bracket part number TC3-0323.
Options 4-6 use bracket part number HHB-8165.
Option 7 use bracket part number ENC-1201 and clamp kit HHB-8206.
5. If the top oven is a Tornado, C3, or Encore remove the legs. This requires two or
more persons—at least one to lift and one to unscrew the legs.
DO NOT REMOVE THE LEGS IF THE TOP OVEN IS A HIGH H BATCH.
6. Remove the screws from the oven that will be placed on top, as marked with
black arrows in the adjacent figures.
7. Place the top oven on the bottom oven.
WARNING: Do not attempt to lift the oven with fewer than 2 people.
WARNING: When lifting, position at least one person on each side.
WARNING: Do not lift the oven from the front and back.
WARNING: Do not lift the oven by the door handle.
8. Align the holes on the stacking bracket with the holes on the top oven and
reinstall the screws.
WARNING: Do not stack ovens over two-high.
WARNING: Any stacking combinations not specified on this sheet will result in
unsafe conditions.
DOC-1032/Revision F/
February 2013