Qa Parameters - Canon MLT (S) User Manual

4. QA Parameters

When MLT (S) frequency processing is selected, the QA parameters (%IP_PARAM%) in
Annotation are displayed in the format below.
REX680 Q3 E5,7,0 D20,3 N5 GCS18,15 R RT+90 Z0 M2,1,1 P1
1 2
This section describes the parameters specific to the MLT(S) (underlined 1 to 4).
For details about the other parameters, please refer to the Operation Manual (Setup Guide).
1 Frequency Processing Mode
If MLT (S) FREQUENCY is selected, Q3 is displayed.
2 Enhancement
The parameter is displayed as: E edge enhancement, edge frequency, contrast boost
Nothing is displayed if the enhancement is disabled.
3 Dynamic Range Adjustment
The parameter is displayed as: D Maximum density, minimum density
Nothing is displayed if both the DARK REGION and BRIGHT REGION are disabled.
If the DARK REGION only is disabled, the parameter is displayed as D*, 3, and if the
BRIGHT REGION only is disabled, it is displayed as D20, *.
4 Noise Reduction
The parameter is displayed as: N Effect
Nothing is displayed if NOISE REDUCTION setting is disabled.
3 4
– 18 –