New Zealand


Table of Contents

Summary of Contents for Black & Decker BDV1084

  • Page 1 Ireland Australia New Zealand...
  • Page 3: Intended Use

    Intended use Never attempt to remove or replace any parts other than those specified in this manual. Your Black & Decker battery charger is designed to charge lead-acid batteries. This product is intended for household, Power cord safety consumer use only. Warning! Never alter the ac power cord or plug.
  • Page 4 Make sure that the initial charging rate does not exceed the Do not smoke or have naked flames in the charging area. battery manufacturer's requirement. Follow the instructions for connecting and disconnecting Warning! Risk of explosive gas mixtures. Working in the vicinity the battery charger leads or battery terminals.
  • Page 5: Use

    For most automotive and similar applications the battery Connect the positive (red) clamp from the battery charger to charger may be connected to the battery while it is the positive (POS, P, +) post of the battery. connected to the dc circuit. If this is acceptable follow the Connect the negative (black) clamp from the battery charger instructions given in "Charging a battery installed in the to the negative (NEG, N, -) post of the battery.
  • Page 6: Function Pushbuttons

    Stage 3 - top-off charge will show a circulating pattern on the digital display (2), to indicate that power has been applied. Select the proper Stage 3 is a top-off charge. The voltage is automatically charge current rate based on battery size. regulated and is reduced to a predetermined level while the current is adjusted for a safe, effective battery charge.
  • Page 7: Troubleshooting

    Part 1 (no load) For estimates of the time it takes to charge a battery, refer to Make sure that there is no load on the alternator by turning the following table: off all the vehicle's accessories. The battery must be fully charged before testing the % of charge in the battery alternator.
  • Page 8: Charging A Very Cold Battery

    Protecting the environment F01 - Internal shorted cell battery If the battery being charged has an internal shorted cell, F01 Should you find one day that your appliance needs will be displayed. We recommend taking your battery to a replacement, or if it is of no further use to you, think certified automotive service centre for evaluation.
  • Page 9: Ec Declaration Of Conformity

    Technical data Black & Decker repair agents and full details of our after- sales service and contacts are available on the Internet at: BDV1084 Input voltage Rated input Please visit our website to Output voltage register your new Black & Decker product and to be kept up...
  • Page 12 90507187 06/07...

This manual is also suitable for:


Table of Contents