Black & Decker Smart Battery Charger User Manual

Black & Decker Smart Battery Charger User Manual

Fully automatic electronicsmart battery charger40/20/10/4 amp charge rateswith 1 10 amp engine start
Hide thumbs Also See for Smart Battery Charger:

Advertisement

VEC1093DBD
Fully Automatic Electronic
Smart Battery Charger
40/20/10/4 Amp Charge Rates
with 1 10 Amp Engine Start

Advertisement

Table of Contents
loading

Summary of Contents for Black & Decker Smart Battery Charger

  • Page 1 VEC1093DBD Fully Automatic Electronic Smart Battery Charger 40/20/10/4 Amp Charge Rates with 1 10 Amp Engine Start...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS Figure Figure ADAPTER (B) WARNINGS 1. RISK OF EXPLOSIVE GAS MIXTURES — WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE GROUNDING THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND GROUNDING...
  • Page 3 Do not connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect to heavy gauge metal part of the frame or engine block. Thank you for selecting the 40/20/10/4 Amp Smart Battery Charger. With 6. For positive-grounded vehicle, connect NEGATIVE (BLACK) clamp from battery charger to proper care and use, it will give you years of dependable service.
  • Page 4: Controls And Indicators

    Stage Two — Absorption Charge maintains the maximum possible charge at a Controls and Indicators constant, safe, predetermined voltage. During this phase, the charging voltage remains CONTROL PANEL DIGITAL READOUT constant, while the actual charging current is reduced to allow for the maximum proper CIRCULATING PATTERN internal chemical energy transfer.
  • Page 5: Charge Rate Selection

    INDICATOR: OPERATING INSTRUCTIONS Large (.375”) 3-Character Digital Display in the upper left of the control panel Ensure that all installation and operating instructions and safety indicates the various conditions and/or status codes: precautions are understood and carefully followed by anyone Status Codes are described in the following chart and on the back of charger.
  • Page 6: Automatic Float Charging

    6. Fill the battery with distilled water according to the manufacturer’s instructions. Pressing the 4/10/20/40 AMP button repeatedly advances to standby mode; Since batteries may rapidly bubble while being charged, remember to refill (only the unit sounds a beep, displays “000” and stops charging. with distilled water) after the equalization process is complete and the voltage is 4.
  • Page 7: Alternator Voltage Check

    With proper care and minimal maintenance, the 4/10/20/40 Amp 12 Volt 3. Press Alternator Check again to stop the test. Smart Battery Charger will provide years of dependable service. For maximum Part 2 performance, manufacturer recommends: Under Load (Accessories ON): Next, load the alternator by turning on as many •...
  • Page 8: Troubleshooting

    TROUBLESHOOTING Display Indications/Common Problems/Possible Solutions No Functions • Check and make sure the charger is plugged into a live 110/120 volt AC outlet. • Follow the steps outlined in the Operating Instructions section. F01 — Internal Shorted Cell Battery If the battery being charged has an internal shorted cell, the F01 will show. We recommend taking your battery to a certified automotive service center for evaluation.

Table of Contents

Save PDF