Table of Contents
Advertisement
Preparation before use
Moving the uDivine
The uDivine is fitted with casters for easy
maneuverability over a short distance.
•
There are 2 ways to move the chair.
Moving Method (1)
•
Raise the backrest fully to its upright
position and retract the footrest fully.
•
Turn the main power switch OFF and
unplug the power plug.
•
Lift the front of the chair as shown in
the diagram below and wheel it to the
desired location.
Casters
sitting on the uDivine
•
The rollers are usually stored in the
upper part of the backrest. This position
is known as the "storage position".
•
If the rollers are not in the storage
position, simply reset by pressing the
power button on the controller before
sitting on the uDivine.
Moving Method (2)
•
Raise the backrest fully to its upright
position and retract the footrest fully.
•
Turn the main power switch OFF and
unplug the power plug from the outlet.
•
Move the chair by lifting it, as illustrated.
•
Do not move the uDivine with someone
in it. This will cause the uDivine to tip
over and cause accident and injury.
Caution
•
It is recommended that a carpet be
placed under the uDivine to prevent
scratching of the flooring and to reduce
noise level during operation.
•
As the uDivine is heavy, please exercise
extra care not to damage the floor
surfaces when positioning it.
•
Maintain a minimum distance of 39
inches from Av devices such as a
television or radio to prevent signal
interference.
•
Use the uDivine only when it is placed
on an even, flat surface.
12
Caution
Hide quick links:
Advertisement
Table of Contents
