Brother P-touch 9700PC User Manual page 11

Lamp condition
Power lamp STATUS
(green) lamp (red)
On Flashing fast
Flashing very
On
Off
■ LED lamp on USB Direct Interface (PT-9800PCN only)
Lamp condition
Colour Condition
—
Green
Flashing
Flashing fast
Red
Flashing very
10
Cutter error
Roller holder error
Print head overheat error
EEPROM error
fast
Circuit board error
On Booting
Off USB device not connected
On USB device connected
HUB connected
Noncompliant USB device
connected
"Buffer full" error with USB Direct
Interface
Overcurrent
fast
Condition
Condition
Remedy
Confirm that the tape is not
jammed in the printer. If necessary,
turn the printer off and on with the
power button. If the STATUS lamp
continues to flash, contact your
Brother dealer or Brother Customer
Service.
Turn the printer off and on with the
power button.
Turn the printer off and on with the
power button. If the STATUS lamp
continues to flash, contact your
Brother dealer or Brother Customer
Service.
—
Remedy
—
—
Disconnect the USB device.
Disconnect the USB device.
Data sent from the bar code reader
is saved on the printer.
Do not use the bar code reader to
consecutively scan bar codes and
do not use the bar code reader with
multiple interfaces at the same time.
Disconnect the USB device and
turn the printer off and on with the
power button.