Brother Multi-protocol On-board Ethernet Multi-function Print Server Network User's Manual page 90
Multi-protocol on-board ethernet multi-function print server and wireless (ieee 802.11b/g) ethernet multi-function print server
Hide thumbs
Also See for Multi-protocol On-board Ethernet Multi-function Print Server:
- Network user's manual (122 pages) ,
- Network user's manual (78 pages)
Table of Contents
Advertisement
LCD messages when using the SES/WPS/AOSS™ control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Error
No Access Point
Connection Fail
m
Click Next.
Wireless configuration for Macintosh
Connection status
Searching or accessing the access
point, and downloading settings from the
access point
Connecting the access point
Connection succeeded.
Session overlap has been detected.
The access point detection failed.
Connection failed.
®
using the Brother installer application (MFC-8890DW only)
Action
Check that only one router or access point has
the SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or AOSS™ mode enabled
and try starting from step c again.
Move the machine closer to your access
point/router and try starting from step c again.
1 Try starting from step c again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.
5
—
—
—
80
5
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Multi-protocol On-board Ethernet Multi-function Print Server and is the answer not in the manual?
Questions and answers