Password; Lan And Wan Port Addresses; Information From Isp - Billion BIPAC 7100G User Manual

Administrator Level
User Level
2. Device IP Network settings in LAN site
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
3. ISP setting in WAN site
Virtual Circuit 0: 1483 Routed IP LLC
4. DHCP server
DHCP server is enabled.
IP address pool from IP Address: 192.168.1.100 to IP Address: 192.168.1.199

3.2.1 Password

The default username and password are admin and password respectively.
If you ever forget the password to log in, you may press the RESET button up to 2
seconds to restore the factory default settings.

3.2.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
IP address
Subnet Mask
DHCP server function
IP addresses
distribution to PCs

3.3 Information from ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of
service is provided such as PPPoE, PPPoA, RFC1483, IPoA, or PPTP-to-PPPoA Relaying.
Gather the information as illustrated in the following table and keep it for reference.
User Name
LAN Port
192.168.1.254
255.255.255.0
Enabled
100 IP addresses
for
192.168.1.100 through 192.168.1.199
(Actually, it can supports up to 253 users.)
admin
user
continuing from
Chapter 3 Configuration
Password
password
password
WAN Port
Obtain an IP address
automatically. ISP assigns
this IP address.
13